|
Originally Posted by synolimit I tried again today. No luck. Im surprised that link to HANS says keep the belts at 20* below horizontal and not above. Maybe its HANS
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
12-10-2015, 07:39 PM
|
#10 (permalink) | |
|
A True Z Fanatic
Join Date: Dec 2009
Location: 03350 Australia
Posts: 1,516
Drives: 09 Nissan 370Z M6
Rep Power: 39975   |
Quote:
2.4 The rear section of the shoulder strap should slope downwards from the uppermost point of contact with the HANSŪ-belt-bearing-surface to the anchorage point on the car, preferably at about 20° below the horizontal, angles between 0° and 20° being acceptable as shown in Figure 4. So it can be between horizontal and maximum of 20-degrees below horizontal ... understanding why they recommend less than horizontal is a question for the FIA and HANS engineers .... I was with you .... horizontal belts were the way to go (in my mind because it is a "straight pull" and absence of spinal compression but since friction between belt and HANS device in integral to its operation, maybe that is the reason ... pure speculation on my part tho' |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Seat belt swap | JaviZ | Exterior & Interior | 3 | 01-20-2014 10:38 PM |
| problem with the seat belt | dudesky | Exterior & Interior | 5 | 01-05-2012 12:25 PM |
| seat belt | Axelsc1 | Wanted | 0 | 12-31-2011 08:01 AM |
| Seat belt rubbing seat | axeman71 | Exterior & Interior | 6 | 08-23-2011 06:46 PM |
| Eliminate Seat Belt | jnaut | DIY Section (Do-It-Yourself) | 9 | 07-07-2010 09:07 AM |
16Likes
Threaded Mode
