Mr. G. Brettin's Slow Motion Leg Hump

gbrettin · 04-07-2021, 03:39 PM

Quote:

Originally Posted by Ghostvette

It would be a whole lot easier to modify the trans mount. Slot the holes that mount to the trans, use star type lock washers under the bolt heads. That way you can mount the crossmember to the frame, then tighten up the trans to the xmember.

Yes, but I need the angle of the engine to sit a specific way for the boost tubes. Otherwise... I'd be all over that. I mean... it shouldn't be too bad. All I need to do is loosen motor mounts and the pull it forward a bit.

If you are wondering why I didn't mark the mounts. I actually did... here comes the but...

BUT..

I mounted the engine mounts on backwards previously. AFTER I mounted it on incorrectly, I put on additional thicker black marks while mounted incorrectly.

This is all learning and fabrication pains. I'm learning tolerances are not necessarily a bad thing.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Racing in Slow Motion IV	MightyBobo	The Lounge (Off Topic)	4	03-12-2013 08:12 PM
Racing In Slow Motion IV	Robert_K	The Lounge (Off Topic)	1	07-13-2012 11:01 AM
Slow shipping slow response slow everything	thispecialk	Nissan 370Z General Discussions	15	11-01-2010 08:23 PM
Racing in Slow Motion	MightyBobo	The Lounge (Off Topic)	2	12-17-2009 03:27 PM
IIHS Small Car Test: Three Gruesome Slow-Motion Crash Videos	AK370Z	Other Vehicles	13	04-15-2009 09:42 AM