|
Haven't had a chance to pick up the mesh yet. Your grille is different than mine in regards to the fangs. The 2016 are molded as part of the grille
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
07-30-2017, 05:32 AM
|
#19 (permalink) |
|
A True Z Fanatic
 
Join Date: May 2016
Location: Calgary
Posts: 3,799
Drives: 16 370z
Rep Power: 94684   |
Haven't had a chance to pick up the mesh yet. Your grille is different than mine in regards to the fangs. The 2016 are molded as part of the grille not the bumper cover like yours, so there was no keeping the fangs in mine otherwise I would have done it. Even in my case wide open like that there is no additional support necessary. I did put the front lip on afterwards though and that more than took care of any concerns about stiffness and support. It would be just fine leaving it like this - though I'm going to do the mesh anyways.
Lousy pic but only one on my phone. 
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 370z Engine remap suggestion after cold intake and full tomei exhaust mods | mousewei84 | Engine & Drivetrain | 6 | 10-31-2016 07:09 AM |
| E46 M3 full exhaust vs 370 w/ stillen G3 cold air | Pearlz370GT | Nissan 370Z Photos / Spyshots / Video / Media Gallery | 4 | 03-24-2013 02:47 AM |
| How cold is too cold? (oil cooler related) | DEpointfive0 | Engine & Drivetrain | 3 | 07-22-2012 04:55 PM |
| Detailer's Domain: 02 Audi S6 Avant - Full Exterior/Full Interior Detail | DetailersDomain | Detailing / Washing / Waxing / Cosmetic Maintenance and Repair | 0 | 09-07-2011 08:16 PM |
| Injen Full Cold Air Intake - Dual setup SP1989P & SP1989BLK | DAN1 | Intake/Exhaust | 21 | 07-30-2009 04:50 PM |
35Likes
Threaded Mode
