Originally Posted by turtle64b

Here's where I'm at right now (picture with painter's tape). I think it looks a little weird only cut in the middle where the intercooler sits, but then again it may not actually look that bad after the mesh goes in. I was hoping you guys might have a few ideas on where to go from here.

My plan:
Cut the middle equal lengths from the intercooler so nothing looks off center (I think the picture angle makes it look worse than it is)
OR
Cut more, following the angle of the fangs up to the top
Get some mesh from Lowes
Paint the matte black portion and mesh gloss black (Or maybe a darker, metallic blue, similar to my BOV?)
Install mesh
Call it a day and enjoy some much lower temperatures!

Thanks for your ideas and inputs!!