Blown Motor, Engine Rebuild/Replacement.

Rusty · 03-14-2014, 09:14 PM

Quote:

Originally Posted by cosmogirl

Actually it will but the small bit I have on my dremel would take forever to do. I will look around for something a bit bigger because if I do keep the kit I want to open up so it can flow as much as possible... Rusty please feel free to chime in here...

Quote:

Originally Posted by Chuck33079

Problem found. You need a cutting tool with more nuts. Hell, Harbor Freight will have a $20 air die grinder that'll work well enough to do the job. The Dremel is for final finishing, not hogging out that kind of metal. You're also using plenty of cutting oil, right?

Yea, you need an air powered 1/4" die grinder with a couple of large football shaped burr bits for roughing. Then a couple of smaller diameter burr bits for finishing. Ball shaped. If you want to go deep into the manifold. Then you need burr bits with a 6" shaft on them. You'll burn up the Dremel on the first port you try to do. I get my die grinders from Sears. I burn them up, and they give me a new one.

Local Sears store has them on stock to boot.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Blown motor!!!!	COSMO	Forced Induction	166	11-25-2013 08:33 PM
Someone in the DFW area who can rebuild a 370z motor	Denny McLain	Engine & Drivetrain	16	01-29-2013 05:27 PM
370z engine blown	Fabsnoop	Nissan 370Z General Discussions	53	06-02-2012 11:29 PM
WORST DAY!!!! Possible engine blown???!!!!	Westwood	Engine & Drivetrain	189	04-09-2012 11:28 AM
vq37vhr ( 370z motor ) NOT BLOWN	soaka1	Wanted	0	03-10-2010 10:01 AM