>>>>>Puckshaw's Boosted Performance Twin Scroll Single Turbo Build<<<<<

FireDan50

I tried DashCommand to read boost also...got crazy numbers :P Don't know why it isn't accurate. Kit sounds good man. Almost makes me want to get my open-pipe external wastegates plumbed into the exhaust. Mine is so loud I can't hear the turbo lol.

__________________
VSR Single-turbo kit: 611hp/517tq @ 10psi (Q16 race gas)
Dan's VSR top-mount turbo 370z

puckshaw

I think it sounds perfect with the recirculating waste gates. Perfect blend of turbo, exhaust, BOV noises


Sent from my iPhone using Tapatalk

__________________
>>>>>BP Build Thread<<<<<

puckshaw

So I've been noodling on this and might know why the boost reading is off. Ideally it would calculate boost using the SAE.MAP PID but that's not available on our car. So instead it calculates CALC.MAP using SAE.MAF, SAE.IAT, SAE.RPM, CONST.ENGINE_DISPLACEMENT, and CONST.VOLUMETRIC_EFFICIENCY. Since the SAE parameters are all available, we just have to put in the engine displacement (which is straightforward) and the volumetric efficiency in the vehicle settings. The tricky one is the volumetric efficiency. There are rough calculations you can do if you have your peak torque value. I'll have that after the tune tomorrow. I can calculate it off of my baseline run but that's not accurate with the turbo now installed. I might play with it a little tonight to see if I can dial it in by trial and error.

__________________
>>>>>BP Build Thread<<<<<