MAF Sensors

Originally Posted by TacoSport10

I had a random limp mode on my car that got more common mid this year. About a month ago I removed the MAFS and cleaned them, and then cleaned the TB’s with them in still. Didn’t disconnect the battery and didn’t have to relearn anything. On first start it did take a few seconds to start, but it’s been almost a month since I’ve cleaned my MAFS and TB and I haven’t had the limp mode come back.

Originally Posted by SouthArk370Z

Torque specs are in the FSM (link in my sig).

Originally Posted by JARblue

Tight is relative to the bolt. Your strength and tools are variables that you need to be able to adjust for. If you are weak and use a 3/4 inch sized socket with a 36 inch breaker bar you're likely to break off the bolt head without any effort at all.

Struts bar bolts and nuts torque to 52 Nm. This isn't some critical number. Just make sure they are tight.

Throttle body bolts torque to 8.43 Nm. Don't want to over torque these too much.

Also, #3 isn't a number. The answer is it doesn't matter the pattern. Just torque them down evenly.