![]() |
1st pic. The very top of the cooler. 2nd pic. Where I ran my grounds to. Still have to apply sealant over the area. 3rd. In the trunk, on the
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#12 (permalink) |
Ronin Samurai - Assassin
![]() Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 69
Posts: 35,508
Drives: 2011 Nismo GM 6M
Rep Power: 2684439 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
1st pic. The very top of the cooler.
2nd pic. Where I ran my grounds to. Still have to apply sealant over the area. 3rd. In the trunk, on the left side. There is a rubber grommet with a wire going throught it. This is where my wiring for the temp sensor and power wires for the pump and fan come through. This is the underside of that grommet. 4th, 5th and 6th pic's. Some pic's of my wiring. The wiring is in heat resistant wiring loom.
__________________
![]() 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Z1 Motorsports 25 row oil cooler install | falconfixer | DIY Section (Do-It-Yourself) | 5 | 05-30-2014 04:32 PM |
7AT 4.08 Gear swap QUAIFE LSD Trans cooler diff cooler | matcop | Engine & Drivetrain | 17 | 09-07-2013 10:09 AM |
Akuma Motorsports Rear Diff Cooler | Kevin@AkumaMS | Engine & Drivetrain | 24 | 05-23-2013 08:01 PM |
Z1 Motorsports Thermostatic Sandwich Plate kit (For Nissan Motorsports Oil Cooler) | Dustin@Z1 | Drivetrain/Engine | 3 | 06-08-2012 11:10 AM |
DIY: GT Motorsports Oil Cooler Kit Install/Review | rackley | DIY Section (Do-It-Yourself) | 28 | 03-10-2010 10:38 AM |