01-23-2013, 08:55 PM
|
#11 (permalink)
|
|
A True Z Fanatic
Join Date: Aug 2011
Location: Ontario, Canada
Posts: 21,749
Drives: Varis Arising II
Rep Power: 51866
|
Quote:
Originally Posted by ENT-Z
Question for you Jason -
How did you plumb up for an oil pressure sensor ( I think you have one, right?). The DIY here on the boards uses the stock location and then you place a T to add the new sensor and retain stock sensor as well. I thought a saw a pic of the kit installed and it looked like this location was already used in the turbo kit to feed the scavenge pump or something like that. I need to pull out the manual and check it out further but wondered what you did.
Thanks!
|
I did it just like the DIY (adding a T fitting) but placed the stock sending unit on the side of the T fitting and the Defi sending unit on the end. That way I didn't have to move the factory wiring like mentioned in the Turbo installation manual.
I can try to get a picture tomorrow. I'm not sure how much can be seen now with the rest of the oil lines in place.
|
|
|
Similar Threads
5798Likes
Threaded Mode
