Mr. G. Brettin's Slow Motion Leg Hump

gbrettin · 04-23-2020, 08:58 AM

IG @gbrettin:
Knockdown, test fit and fill... Yup. Again. All the problem areas have subsided. Last time going through the rough grit on this. I can start working on wet sanding next.

-----------------------------

I know these posts are a bit repetitive; but, it'd rather show what actually goes into the actual mould making process.

Hotrods - The Dewalt has a little bag that has been catching 85% of the dust (which has been amazing). I just so happen to have a small shop vac at the shop. I'll hook that up!

Something to be said about the edges on the mould... I have the edges roughed out and will need to dedicate a ton of hours getting them perfect. I have been slowly building the edges up, specifically with tooling gel since it's hard AF.

It's getting there.

More sanding supplies

Test fit. Edgest will be built up.

More Sanding

Skim Coat

Rusty · 04-23-2020, 01:51 PM

I have the same DO sander. That bag doesn't catch chit. When I'm using mine. I duct tape my shop vac to it. It will also make your disks last longer too.

04-23-2020, 01:51 PM	#2 (permalink)
Rusty A True Z Fanatic Join Date: Dec 2011 Location: Fayettenam,Pennsyltucky Age: 70 Posts: 35,579 Drives: 2011 Nismo GM 6M Rep Power: 2684440	I have the same DO sander. That bag doesn't catch chit. When I'm using mine. I duct tape my shop vac to it. It will also make your disks last longer too. __________________ 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Racing in Slow Motion IV	MightyBobo	The Lounge (Off Topic)	4	03-12-2013 08:12 PM
Racing In Slow Motion IV	Robert_K	The Lounge (Off Topic)	1	07-13-2012 11:01 AM
Slow shipping slow response slow everything	thispecialk	Nissan 370Z General Discussions	15	11-01-2010 08:23 PM
Racing in Slow Motion	MightyBobo	The Lounge (Off Topic)	2	12-17-2009 03:27 PM
IIHS Small Car Test: Three Gruesome Slow-Motion Crash Videos	AK370Z	Other Vehicles	13	04-15-2009 09:42 AM

04-23-2020, 08:58 AM	#1 (permalink)
gbrettin A True Z Fanatic Join Date: Oct 2010 Location: Portage, MI Posts: 2,304 Drives: Tricycle Rep Power: 589452	IG @gbrettin: Knockdown, test fit and fill... Yup. Again. All the problem areas have subsided. Last time going through the rough grit on this. I can start working on wet sanding next. ----------------------------- I know these posts are a bit repetitive; but, it'd rather show what actually goes into the actual mould making process. Hotrods - The Dewalt has a little bag that has been catching 85% of the dust (which has been amazing). I just so happen to have a small shop vac at the shop. I'll hook that up! Something to be said about the edges on the mould... I have the edges roughed out and will need to dedicate a ton of hours getting them perfect. I have been slowly building the edges up, specifically with tooling gel since it's hard AF. It's getting there. More sanding supplies Test fit. Edgest will be built up. More Sanding Skim Coat