Madwi's picture dump and crap

madwi · 05-14-2021, 10:36 AM

Plan on tapping into where the oil temp sensor goes on the block for turbo oil feed. Anyone see any issues with this plan?
I ordered some fittings that were mentioned in the 'Add a oil pressure gauge' diy thread.

Rusty · 05-14-2021, 10:42 AM

Depending on how much volume you need. If you need more volume, the line for the oil cooler would be a good place to tap into. Otherwise. I think you're fine.

redondoaveb · 05-14-2021, 11:25 AM

Quote:

Originally Posted by Rusty

Depending on how much volume you need. If you need more volume, the line for the oil cooler would be a good place to tap into. Otherwise. I think you're fine.

^this. I tee'd off my thermostatic plate for my sc. The fitting on the supercharger was designed to restrict the amount of flow.

madwi · 05-14-2021, 11:59 AM

Quote:

Originally Posted by redondoaveb

^this. I tee'd off my thermostatic plate for my sc. The fitting on the supercharger was designed to restrict the amount of flow.

Sounds good, Ill order up some fittings.

JARblue · 05-14-2021, 11:47 AM

Quote:

Originally Posted by madwi

Plan on tapping into where the oil temp sensor goes on the block for turbo oil feed. Anyone see any issues with this plan?
I ordered some fittings that were mentioned in the 'Add a oil pressure gauge' diy thread.

Thank you for the inspiration

I finally ordered these fittings for my oil pressure gauge that I've had sitting around for nearly 2 years now

05-14-2021, 10:42 AM	#2 (permalink)
Rusty A True Z Fanatic Join Date: Dec 2011 Location: Fayettenam,Pennsyltucky Age: 70 Posts: 35,574 Drives: 2011 Nismo GM 6M Rep Power: 2684440	Depending on how much volume you need. If you need more volume, the line for the oil cooler would be a good place to tap into. Otherwise. I think you're fine. __________________ 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Open Dump exhaust	Wabbyyy	Intake/Exhaust	14	10-04-2019 10:02 AM
Gen Coupe dump 4turbo	7speed	Other Vehicles	17	07-29-2014 09:58 AM
ECU Dump ?'s	ZScr3am	Tuning	2	10-27-2012 04:40 PM
ECU dump turnaround time	SS_Firehawk	Tuning	9	05-07-2012 08:36 PM
My Beltronics RX65 Took a Dump!	Rhinetom	Nissan 370Z General Discussions	12	01-07-2011 10:45 AM

05-14-2021, 10:36 AM	#1 (permalink)
madwi A True Z Fanatic Join Date: Sep 2012 Location: West Michigan Posts: 31,410 Drives: Granma red Z Rep Power: 2684430	Plan on tapping into where the oil temp sensor goes on the block for turbo oil feed. Anyone see any issues with this plan? I ordered some fittings that were mentioned in the 'Add a oil pressure gauge' diy thread.