|
Originally Posted by Megan370z if you say so... it all has to work together at the end. I say you are still leaving some power under the table. im not
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
07-01-2014, 08:05 AM
|
#11 (permalink) | |
|
A True Z Fanatic
Join Date: May 2013
Location: Columbus, OH
Posts: 5,051
Drives: 2013 Silver 370z
Rep Power: 3390   |
Quote:
Stillen 2.35" through and through, smooth flow. Mine 2.5" then 2.35" then 2.5" then 2.35" etc, a little bumpy even though I knife edged the 2.35" sections on both sides. Possible new cai, 2.5" ID sections where silicon is, then new sections of 2.75" OD. Now I'm not sure of the ID on the 2.75" OD pipe (2.63" i think, 0.11 wall) but I'll have to stretch the silicon sections at the connections. This will make the flow also bumpy as the silicon will be smooth, then open up larger than 2.75", then the air will hit the knife edge of the 2.75" OD pipe. While that's the most cubic inches in size, it'll probably be the least free flowing. in case you didnt get that i mean this...while id have all sections now bigger than the TB opening, wouldnt this hurt flow some? 
__________________
13 370z- Last edited by synolimit; 07-01-2014 at 08:28 AM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Custom ported and CNC throttle bodies, upper and lower manifolds | synolimit | Exhaust/Intake | 297 | 06-25-2021 09:13 AM |
| [WTB] Lower intake manifolds! Uppers and TB's welcome!! | synolimit | Parts for sale (Private Classifieds) | 0 | 11-19-2014 02:02 AM |
| Smokeys dyno, ported TB's, manifolds etc | synolimit | Tuning | 8 | 08-15-2014 11:11 AM |
| can the throttle bodies be taken off? | boomboom | Engine & Drivetrain | 9 | 11-03-2013 01:46 PM |
| Kinetix 370Z/G37 Velocity Upper Intake Manifolds - Z1 Motorsports | Dustin@Z1 | Intake/Exhaust | 151 | 03-18-2013 09:37 AM |
487Likes
Threaded Mode
