Custom ported and CNC throttle bodies, upper and lower manifolds by Synergy Composite

Originally Posted by Megan370z

you will need to adjust the idle screw which look to be locktighted very strongly btw.

then if you know what you are doing with the tune. you wont have any problem



again,
I prefer to mention it often, you need a different intake setup other than OEM because you MUST have a bigger intake tube especialy the MAF tube. if you arent doing it right , boring a TB to his maximun as I did , you wont get much of any gain
this is boring 2.5mm out , cut the shaft in half , flush screws , arrow edged butterfly plate.

edit again ,,, if you dont have a very good flowing exhaust ... forget about this mod ! ,,

Originally Posted by F.I. Inc.

Yes, they are Tony approved! Frank, when I get around to it, I may put your pipes into production. We will call them, "The FP" option.
-Tony