Custom ported and CNC throttle bodies, upper and lower manifolds by Synergy Composite

Originally Posted by synolimit

Would z1's really matter? If I dyno again as is and put down 295/246 that I do, add our mani and it puts down say 10hp increase in the mid range where it counts and maybe a few up top so the peaks read 299/250, does another manifold need to be even mentioned if our mani shows goods gains and is half the cost or even less with better porting done?

The vender thing I'll have to talk with the owner on. I might just say, here's their website. Call or go there or mail your stuff in to get done. Wouldn't be any different than saying Discount Tire did a great alignment for me, go see them.

Originally Posted by Sh0velMan

Only matters if you say "It is better than Z1's manifold" which you suggested it might be in a previous post, that's all.

Originally Posted by F.I. Inc.

Yes, they are Tony approved! Frank, when I get around to it, I may put your pipes into production. We will call them, "The FP" option.
-Tony

Originally Posted by Sh0velMan

Only matters if you say "It is better than Z1's manifold" which you suggested it might be in a previous post, that's all.

Originally Posted by synolimit

Gotcha. Well all i want to say is their porting is rough because they said really smoothing it did nothing power wise but cost went up. I think we can port smooth so it looks quality and price is lower. Power wise I bet they are even. I mean let's be real, we are only removing a mm or two from the part. One company can't out do another on that point.

Originally Posted by Sh0velMan

There may be a knowledge issue, but that can be gotten around with enough trial and error.

I suspect that Z1 probably ruined a fair number of these plenums before they found the results they wanted. Your guy gets one shot at it, if it works it works, if not it doesn't.

Like I said, I hope it works, can't wait to see results.