Blown Motor, Engine Rebuild/Replacement.

Rusty · 03-16-2014, 08:53 PM

Quote:

Originally Posted by 1slow370

burrs leave a shitty finish tho i recommend using some spiral rolls on an arbor for clean up, and they are cheap at harbor freight, spiral rolls are the way to go on aluminum too if you plan to port anything else. if you for some crasy reason decide to use a burr on anything aluminum make sure to use copious amounts of wd40 or a lube like LPS

What you can do to is. Get a piece of 1/4" diameter metal rod. Cut a slot in one end of it about one inch long with a hack saw. Now get a piece of emery paper about one inch wide and about six inches long. Fold it up twice, and stick it in the slot in the end of the rod. Now you can use that for polishing up the rough areas. You can use different grits of emery paper for different finishes.

Aluminum takes a different type of burr bit. One used for hard metals will clog up. It has to be a courser bit.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Blown motor!!!!	COSMO	Forced Induction	166	11-25-2013 08:33 PM
Someone in the DFW area who can rebuild a 370z motor	Denny McLain	Engine & Drivetrain	16	01-29-2013 05:27 PM
370z engine blown	Fabsnoop	Nissan 370Z General Discussions	53	06-02-2012 11:29 PM
WORST DAY!!!! Possible engine blown???!!!!	Westwood	Engine & Drivetrain	189	04-09-2012 11:28 AM
vq37vhr ( 370z motor ) NOT BLOWN	soaka1	Wanted	0	03-10-2010 10:01 AM