Topgunz - air to air upgrade

deportedflip · 07-13-2018, 07:12 AM

Quote:

Originally Posted by TopgunZ

Thats awesome! Did you have to cut any of the Y pipe? IC brackets fit right up? Looks like the hot side pipe (L pipe) needed an extension.

I bet you can get by with a bigger filter. I can send you a link to one if you want that will probably gain a psi.

Also, I noticed your manifold cooler is still in there. That thing should definitely come out. I know it sucks taking the manifold off but it will be worth it.

the intercooler brackets mount up but you can only use two bolts on each one that i feel is enough to hold it on. this picture was taken before i moved it around, the intercooler bolts up to both sets of holes if that makes sense. i ended up moving it over cause it looked stretched.

I also did remove the manifold cooler it was just something i did after mounting up everything. I don't think a bigger filter will fit in the space i have, it was a challenge and a half trying to wiggle the blower assembly back into where it sits.

Ill chime back in as my tuning continues as I am remote tuning. Ill probably jump on a dyno eventually and ill also throw that in here.

Thanks again for sharing the kit with everyone!

TopgunZ · 07-13-2018, 07:29 AM

Quote:

Originally Posted by deportedflip

the intercooler brackets mount up but you can only use two bolts on each one that i feel is enough to hold it on. this picture was taken before i moved it around, the intercooler bolts up to both sets of holes if that makes sense. i ended up moving it over cause it looked stretched.

I also did remove the manifold cooler it was just something i did after mounting up everything. I don't think a bigger filter will fit in the space i have, it was a challenge and a half trying to wiggle the blower assembly back into where it sits.

Ill chime back in as my tuning continues as I am remote tuning. Ill probably jump on a dyno eventually and ill also throw that in here.

Thanks again for sharing the kit with everyone!

Sounds good. Let me know what modifications that were required because there have been a handful of other 350 HR guys wanting the kit but I had been telling them I doubt it will fit. Do you have this posted on any 350 sites?

deportedflip · 07-13-2018, 08:39 AM

Quote:

Originally Posted by TopgunZ

Sounds good. Let me know what modifications that were required because there have been a handful of other 350 HR guys wanting the kit but I had been telling them I doubt it will fit. Do you have this posted on any 350 sites?

i have it posted on a nismo page but no out right 350 sites. i need to remove the front bumper to see where i cut. the y pipe could be adjusted a bit to make fitting it easier. you do need to widen the hole that leads it into the engine bay but that could be fixed by changing the angles. also making the first throttle body cupler an inch or so longer would make mounting it all up way easier.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Best upgrade/mod for 200-300$?	louiey370z	Engine & Drivetrain	10	06-09-2015 11:59 PM
Upgrade?	Dzel	Other Vehicles	83	03-08-2014 05:55 PM
Upgrade	Darryl79	New Roadster 370Z Owner	7	08-23-2012 02:21 PM
Big 3 upgrade ???	dbkustomz	Audio & Video	6	06-30-2012 07:00 AM