|
Topgunz was spot on with figuring out what filter would work best with the air to air setup. Fits almost perfectly and sits in there very snug. From the front
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
04-19-2016, 02:29 PM
|
#11 (permalink) |
|
Enthusiast Member
Join Date: Oct 2014
Location: OKC, OK
Posts: 316
Drives: 2010 370Z 7AT S/C
Rep Power: 18   |
Topgunz was spot on with figuring out what filter would work best with the air to air setup. Fits almost perfectly and sits in there very snug. From the front you can see that this setup will be getting plenty of cold air. For the filter to fit better and for piece of mind, I used a small 1/8"x 1/2" rubber spacer that I placed on the lip of the supercharger inlet before I slipped on the air filter. This just allowed for a much tighter grip.
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34 |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best upgrade/mod for 200-300$? | louiey370z | Engine & Drivetrain | 10 | 06-09-2015 11:59 PM |
| Upgrade? | Dzel | Other Vehicles | 83 | 03-08-2014 05:55 PM |
| Upgrade | Darryl79 | New Roadster 370Z Owner | 7 | 08-23-2012 02:21 PM |
| Big 3 upgrade ??? | dbkustomz | Audio & Video | 6 | 06-30-2012 07:00 AM |
1908Likes
Threaded Mode
