DIY: Oil Cooler (scratch built install, lottsa pics).....>.

Holliday · 12-14-2010, 12:58 AM

^^ Looks Good

^^

bigrob126 · 01-23-2011, 06:39 PM

I dont even have my 370 yet, but am likely going to do this mod. Was wondering if you used the same mock bracket up top as at the bottom and is there a place to mount the top, such as the lower composite piece used?....and does this mounting setup leave a space between the oil cooler and the rad, or do they touch, in which case I would need some rubber in between?

Thanks!!

Rob

Nikkolai · 08-05-2011, 08:35 AM

Would there be a difference between using -8 lines instead of -10? I installed everything in the DIY except that I used smaller lines. In 105 degree F heat, it averaged a little below 220. Does that sound right? It never went over that while I was pushing it a little bit here and there.

New update:
I think it is fine. I have been cruising around and the temparture is at 190 in 105 F degree weather.

12-14-2010, 12:58 AM	#1 (permalink)
Holliday Track Member Join Date: Aug 2009 Location: Cache, OK Age: 40 Posts: 916 Drives: in the fast lane.... Rep Power: 18	^^ Looks Good ^^ __________________

08-05-2011, 08:35 AM	#3 (permalink)
Nikkolai Base Member Join Date: Jun 2010 Location: DFW Posts: 238 Drives: Boss 302, Frontier Rep Power: 16	Would there be a difference between using -8 lines instead of -10? I installed everything in the DIY except that I used smaller lines. In 105 degree F heat, it averaged a little below 220. Does that sound right? It never went over that while I was pushing it a little bit here and there. New update: I think it is fine. I have been cruising around and the temparture is at 190 in 105 F degree weather. Last edited by Nikkolai; 08-07-2011 at 06:04 PM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved)	djpathfinder	DIY Section (Do-It-Yourself)	21	11-30-2015 05:47 AM
Real Auto Dynamics built and R/T tuned built motor TT	Mr.Squeeze	Forced Induction	132	04-18-2014 06:09 PM
Anyone done a DIY for a 34r cooler install?	bigdog1250	DIY Section (Do-It-Yourself)	7	07-05-2012 10:38 AM
Oil Cooler Install	Zedx	Engine & Drivetrain	10	05-19-2011 02:35 AM
install oil cooler?	Mt Tam I am	Nissan 370Z General Discussions	5	08-25-2010 09:08 AM

01-23-2011, 06:39 PM	#2 (permalink)
bigrob126 Base Member Join Date: Jan 2011 Location: Las Vegas NV Posts: 134 Drives: 2009 370Z Sport Auto Rep Power: 16	I dont even have my 370 yet, but am likely going to do this mod. Was wondering if you used the same mock bracket up top as at the bottom and is there a place to mount the top, such as the lower composite piece used?....and does this mounting setup leave a space between the oil cooler and the rad, or do they touch, in which case I would need some rubber in between? Thanks!! Rob