DIY: Finally Installed The STILLEN G3 Intake today! Lots of Pics inside (AK370Z)

AK370Z

haha no problem. I am usually stickler for following rules, so I was looking for the 2nd clip(as I was instructed). I looked everywhere but didn't see it. Then I started pulling back and forth thinking maybe I have 1 clip. After few minutes, I realized it's impossible to take off. I go get a cold drink and started looking at the thing again and that's when I saw the bolt.

Def, anything missed on the previous DIY, can be found in this thread. Members will benefit from it.

I def cheaped out . I should have listened to you

How long does it take the ECU to adjust itself?

__________________
The370Z Signature Pictures ll Want to rock our forum decals on your car? Then click here! ll How to Embed YouTube Videos In a Post
STOP! (Hammertime) ll Become a Premium Member Click HERE ll F.A.Q.
Are You a Nissan Dealer? Click Here to Become A "Supporting Dealer" and Start Listing Your 370Zs In Our Inventory Section
My Monterey Blue Z ll My Exhaust --> My Intake --> G3
Nissan's Official Response Regarding Oil Temp Issue: CLICK HERE
Need a Set of Cheap Winter wheels /Tires? Then Visit The Banner Link Below and Place Your Order. You'll Help Keep The370Z Alive.

Josh@STILLEN

I was enamored by the cutting tool in the youtube link I had sent you on the G35 Gen 3 install where the guy went crazy with the hole size, but did it in about 3.5 seconds.. LOL

I'm no expert, I've never cut the core support to accommodate the pipes.. I've got an '04 G35.. my experience is just with that install, but I've seen some good results with some of the hand tools that are out there.. who knew it was partially due to the accessories they are driving, not just the unit itself.

ECU is quick, but we advise those doing the back to back dynos that we typically see full results within 7-8 dyno runs, when most places like to run 3 for consistancy. So as long as you've gotten a chance to let it run through the RPM band in a couple of gears for a good amount of runs, the ECU will be right there.

Love the sound of those intakes once it seems to hit it's sweet spot around 5,500 RPM and above.. sounds angry.. and even more so on the dyno when you're standing in a spot outside the car you wouldn't normally have access too..