![]() |
I'm kind of on the fence about warp, I just know that in the old days, when all the auto parts houses would turn the rotor, when we clamped the
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#10 (permalink) |
|
Track Member
Join Date: Feb 2013
Location: FL
Posts: 834
Drives: 2019 Civic Type R
Rep Power: 16 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
I'm kind of on the fence about warp, I just know that in the old days, when all the auto parts houses would turn the rotor, when we clamped the rotor to the lathe and just rotated the rotor against the lathe bit there would indeed be an uneven surface. Thinking back none of us questioned the "trueness" of the lathe, the trueness of the rotor mounting face, we just turned the rotor until the high spots were gone and put it back on the car and the problem was solved. Usually we saw rotors that were ran several years on the metal face of the worn out pad by drivers that had no idea what the noise was but they KNEW it would cost them money so they just kept on going, haha.
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SC 370z problem | geohartanto | Forced Induction | 14 | 12-05-2011 01:03 AM |
| Another problem with my 370Z | plumber78 | Engine & Drivetrain | 10 | 06-24-2011 07:30 AM |
| I think i found a problem with my 370Z... | Juruki | Nissan 370Z General Discussions | 43 | 07-19-2010 11:19 AM |
| 370Z Not Cranking Problem | Master_Ly | Nissan 370Z General Discussions | 38 | 05-06-2010 10:50 PM |
| New Roadster, Spoiler problem, dealer problem | Hello | Nissan 370Z General Discussions | 26 | 01-11-2010 06:22 PM |