going square how did you like it?

synolimit

spacers???? my 18x10.5 +15 rpf1 is perfect in the back. what spacer do you need back there? also 18x10.5 +15 for the front is crazy offset anyways. am i missing something or do you have a different wheel? i only see 1 18x10.5 from enkie.

if i did a 10.5+15 on the front (again i only see 1 rpf1 in 18x10.5) where im flush now, itd be like putting a 23mm spacer on.

__________________
13 370z-

bkleeman

Same wheel front and back. We're only using spacers on one end, but I dont recall which - I'm 600 miles away from the car at the moment so I can't go look. Our rules allow for a 10.5 wheel up front and an 11 in the rear but Enkei doesn't make an 11 and that's the only offset for a 10.5 so that's what we went with. We go through a LOT of wheels so I wasn't going to switch over to a more expensive wheel just to get an 11.

The Pirellis we use have a rather tall sidewall and we can adjust ride height so we have a lot that we can play with regarding fit.

__________________
Brian Kleeman
Nissan 370Z - Pirelli World Challenge GTS #07
D.W.W. Motorsports | DXD Racing Clutches | SPL Parts | Aeromotions.com

synolimit

Wow. Well if you're 100% ill take your word. But that wheels like a 51mm spacer on the oem. I'm 23mm smaller and 1.2" lower with -1.5 camber and poke 1/8". Maybe you run -4 camber?

__________________
13 370z-

bkleeman

I dug through my pics...spacers on the rear, nothing up front. -3.0 to -3.5 camber on the front, -1.5 to -1.8 on the rear. Tires are 305/660 front, 305/680 rear.

__________________
Brian Kleeman
Nissan 370Z - Pirelli World Challenge GTS #07
D.W.W. Motorsports | DXD Racing Clutches | SPL Parts | Aeromotions.com

wstar

Off-topic divergence here, but any chance you guys will be selling whatever you made for hooking up ducting to the front rotors? I have the Stillen ones now, but more airflow would be nice and I suck at fabricating these kinds of things

I suspect this is due to series rules.

__________________
7AT Track Car!
Journal thread / Car setup details

synolimit

O come on. You can do it. What I did was very easy! The OEM dust shield has a square whole in it. I held up my 2" pipe around it and marked a round hole and cut it out with a grinding bit. It your stillen doesn't have a hole then just get a 2" hole saw bit and punch through it. Then I cut some strips of metal and bent them 90*. Held one end to the pipe and used a self taping screw to hold it. The other side got screwed to the dust shield. I think I used 3 "brackets" on each side. Won't done just paint it us so it won't rust.

__________________
13 370z-