Sh0velMan's Track Car Build

Sh0velMan · 11-01-2013, 10:35 AM

Quote:

Originally Posted by wstar

Could be a damaged wire run to one of those sensors, too. Could check that with a meter on the connectors and the wiring diagrams for the sensors in the EC section of the manual. But yeah, if that doesn't work, just cut more wires till the car stops bitching

It's possible, but those harnesses ride inside the one that runs down the side of the tranny, so I don't have any reason to think they'd be damaged like the main O2 sensor (drivers side) was from the heat.

Still kicking myself for letting that happen, but I repaired the harness... I just hope it didn't do something to that sensor that's making it blow the fuses.

As a diagnostic step I'm going to disconnect the secondary sensors and do a drive cycle, see if it pops the fuse. If it does not, I will do a few more cycles until I am satisfied and then figure out where to get some O2 bung plugs.

If that does not make any difference, I'll have to sit down with my multimeter and the main sensors and see if I can find a high impedance conductor or something. Sigh.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wh1te370z - BMW 328is Track Car Build	wh1te370z	Other Vehicles	25	03-22-2012 10:21 AM
United touge/track drivers Streets of Willow Track Day	K.R.O.P.S.	Southern California Region	0	10-05-2011 07:25 PM
Forged Performance: R35 GT-R Track Day Build	ChadB@Forged	Track / Autocross / Drifting / Dragstrip	2	06-10-2011 09:40 PM
Datsun Roadster 1600...To build or not to build	motoextreme	The Lounge (Off Topic)	66	02-13-2010 12:40 AM