Custom ported and CNC throttle bodies, upper and lower manifolds by Synergy Composite

Megan370z · 07-01-2014, 10:36 AM

Quote:

Originally Posted by N0SL3N

I would think with the intake you would want to have the largest ID at the filter and the smallest at the TB. That way you can increase the velocity of the air flow into the manifold. If you have restricted sections (by the MAFs) you will be creating a vacuum that prevents the maximum amount of air from flowing.

So I would think you want something like 2.75" - 2.5" - 2.35".

Depend what your goal is . This is partialy true.
If your pre-throttle tube is smaller than the Tb itself and the Maf . You are killing the throttle respond which for an N/a setup isnt something you want.

But I totaly agree from the filter up to the entry of the maf tube. Should be bigger
this is what was done on my custom cai... starting from 3" down to 63.5mm.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Custom ported and CNC throttle bodies, upper and lower manifolds	synolimit	Exhaust/Intake	297	06-25-2021 09:13 AM
[WTB] Lower intake manifolds! Uppers and TB's welcome!!	synolimit	Parts for sale (Private Classifieds)	0	11-19-2014 02:02 AM
Smokeys dyno, ported TB's, manifolds etc	synolimit	Tuning	8	08-15-2014 11:11 AM
can the throttle bodies be taken off?	boomboom	Engine & Drivetrain	9	11-03-2013 01:46 PM
Kinetix 370Z/G37 Velocity Upper Intake Manifolds - Z1 Motorsports	Dustin@Z1	Intake/Exhaust	151	03-18-2013 09:37 AM