Injen cold air intake

XwChriswX

With Injens you will need to fab the washer fluid reservoir. So either way you go you have to mod something. I figure the less I'm doing with hard points like that, the easier it is. With the stillens if you have a keyhole saw or dremel, it will take you seriously only 10 minutes to cut the support. You'll be ok I promise.


Plus, aside from STILLENS advertising, consistently high numbers have been seen with Stillens in independent dynoing. The Injens are a good one to consider, but with the stock front end, I just don't see them getting as much unobstructed airflow.

Other options are the Akuma intakes and AAM Intakes. Both have similar filter placement to the Stillens at a lower cost.

__________________

Bonnie - Stage 2, Audio build coming this fall!
R.I.P. Abby 3/29/10 - 3/30/14