Another DIY Twin Turbo kit (COMP oil-less turbos)

Boosted Performance

Nice work...and yes the passenger side is the PITA. When I did this back in the day on my 350z, I figured external wastegates would be the best option:




I found that the passenger turbo clocking was difficult but it worked out:



You will find that the IC pipes will be a bit of a pain, but it looks like you put the turbos a bit further back than I did, so it may not be too bad.

Good luck with the build, and post a lot of pictures.

__________________
750WHP starting @ $7,500 to the door
FOR DETAILS VISIT: http://www.the370z.com/members/boosted-performance.html
FB: https://www.facebook.com/Boosted-Per...6303179791462/
IG @boostedperformanceyeg

thangcu35

Yes it would have been much easier had i went with external gates, but going internal saves me $600. I pushed the turbo farther back so I can run a short filter right off the compressor housing, with a hydro shield. This gives me room to run the charge piping through the wheel well to the IC. As long as i can get the driver side to work, the passenger side should be cakewalk.

I have modified the wastegate bracket to allow the actuator to hug closely to the housing. This pretty much solved the low clearance issue. Its currently sitting right at same level as my resonated test pipes and this is safe enough for me.