Topgunz - air to air upgrade

StillenZ84

Well guys I hit 535/412 on some belt slip only hitting 10.5 psi. Ima have to figure out how to secure the front belt a little more. I have the tension pulley and larger belt in the front but I still think it is a little loose. Anyway happy with the numbers for what it is for sure. Shows what the kit is capable of.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34

ANMVQ

Nice man!

Was wondering if you are running the SC support arm also? The Stillen bracket has been bent a few times.

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

StillenZ84

No I am not. Just have the 3" idler pulley on the supercharger side. Mine so far is holding strong and hasn't bent.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34