Topgunz - air to air upgrade

future370zzz

What tires are you on? It's not getting swirly at 500whp? I got hankook v12 evos and they get swirly with the small amount of power I have at full takeoff. Can't image at 500whp especially on the dig run with the evo.

__________________

StillenZ84

Im on Mickey Thompson ET Streets. Those paired with Ecutek's adjustable traction control I can take off from a dig and not spin at all. From a dig I keep the TC on around 15% and Im good. If I turn it all the way to 0% I will roast the tires off for sure. From a roll I keep it on about 5% and usually never have any problems. That is from a 40 and up. Anything lower I might have to take the TC up a little. Just depends on the road.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34

future370zzz

EcuTek options coming in handy. MT only on the rear? Stock up front?

__________________

StillenZ84

They definitely come in handy. EcuTek is amazing. 305/35/19 MT's on the rear and 265/35/19 RE-11's up front.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34

Z&I

Yep ... the M/T's really helped with the traction and the wheel hop.
Waiting on my car to finally be done - have gone with EcuTek T/C as well.
Can't wait to drive it again after 2 1/2 yrs.

__________________
.
BB

BOLIO 671

What RPM are u launching at from a dig?

__________________
2013 Nismo Z34 / FI TT #091 / IG: @lilzilla_z34

StillenZ84

I have a built auto but with Sebz launch hack I can stall it up to 2500 or so when I dig.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34