08-09-2016, 03:30 PM
|
#11 (permalink)
|
|
Enthusiast Member
Join Date: Oct 2014
Location: OKC, OK
Posts: 316
Drives: 2010 370Z 7AT S/C
Rep Power: 19
|
Quote:
Originally Posted by milkcow500
Hey guys, is this correct? I installed the tial, but I'm only getting half my psi now. I don't remember the coupler to the sc being crimped so badly.  
Sent from my SM-N910V using Tapatalk |
Yeah no way it can be that crimped. Adjust the couplers on the intercooler and BOV and pull the pipes out where they aren't as deep into the couplers but make sure there is at least 3/4-1" of the pipe still inside the coupler where the clamps can get a good grip. That should straighten up that coupler on the volute quite a bit where it isn't crimped like that.
__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34
|
|
|
Similar Threads
1908Likes
Threaded Mode
