Topgunz - air to air upgrade

StillenZ84

My progress for today. Have everything basically mounted the way the pipes are going to go. Clocked the supercharger down so there aren't as many bends in the piping. Mounted the supercharger to make sure everything fit and it is looking good. Just need to install the blockoff plate, air filter, a few couplers, and all of the clamps so there are no boost leaks. Went with another filter that will be here beginning to mid week. Will throw it on when it gets here and should be tuning by Wednesday.

Attached Images

	IMG_2374.JPG (609.9 KB, 144 views)
	IMG_2375.JPG (585.4 KB, 99 views)
	IMG_2376.JPG (598.9 KB, 112 views)
	IMG_2377.JPG (574.8 KB, 124 views)
	IMG_2378.JPG (329.2 KB, 118 views)
	IMG_2373.JPG (646.2 KB, 132 views)

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34