P010C, - 1. Run a new wire between the bank 2 MAF sensor and terminal 79 of the ECM or trace the harness to try to locate the broken wire.
Tech Tips: The wiring diagram does not show a connector between the MAF sensor and the ECM. Bank 2 is the driver's side. The ECM is located behind the right (passenger) side of the dash.

P1092 this code is something to do with VVEL CONTROL SHAFT POSITION SENSOR.

Did you extend your MAF wires your self and solder them?

Or did stillen provide you with new extended maf cables.

I am going to look and make sure everything is hooked up properly. I am using the stillen maf extention for the drivers side maf. It might be bad.

Sent from my SM-N920V using Tapatalk

Flutter isnt bad but the Tial does stay open in every gear till around 2000 rpm light throttle. I occasionally get some flutter around 2200 rpm but not too often. It is definitely loud. haha Turns plenty of heads. Im working this weekend on adding some padding to places that the pipe is hitting the frame because it is tirggering my knock sensor and havent been able to get but a few good log for Seb. I have hit 9 psi at 6000 rpm and the car is a whole other animal with the new kit.

Well the VVEL code is cleared. Connecter wasn't fully seated. Now just have to figure out the Maf code.

Sent from my SM-N920V using Tapatalk

What psi were u hitting before?

Can you take a pic where it's hitting the frame? I can't even see how it's possible.

Maybe where the tubing goes through the radiator support or where the blower is clocked. Those are the only placesit comes close to metal on the car on mine.

Sent from my SM-N920V using Tapatalk

The volute was initially touching right after install and I had to move it up 1/2'-3/4" so it wouldn't hit. There was also a place on the cold side where the pipe came through the engine bay that was leaning against the metal. I put a rubber boot in-between them to try to stop it. Also the strut bar was rubbing on the intake right before the TB's, so I added a little padding.

I was just under 10 psi at redline before.

Ok I can see where it could hit coming in through the shroud.
I snapped a pic of the normal y pipe at the throttle bodies and this design won't hit the sway bar.
http://i1070.photobucket.com/albums/...pssuxitiye.jpg

And coming through the shroud there's a ton of space.
http://i1070.photobucket.com/albums/...pslfwwoggn.jpg

Nice so ur hitting boost earlier @ 9psi @6K rpm.....hopefully those padding did the trick so u can get some clean pulls for ur Data Logs....What are ur intake temps looking like? Are they close to ambient?

Yeah hopefully it did the trick. Intake temps are incredibly low compared. It has been mid to high 80s during the day here and my intake temp never gets over 90-95 WOT. I did a few pulls tonight with no knock so Im hoping all goes smooth tomorrow. Was 65 and intake temps didn't go above 75 WOT.

Hoping for some more vids soon....

So is it common for the Stillen Maf extentions to not work?

Sent from my SM-N920V using Tapatalk

Ill take some of the dyno pulls.