Topgunz - air to air upgrade

BOLIO 671 · 05-26-2020, 11:23 AM

Quote:

Originally Posted by NissanTracker

Just got the V1 kit installed on my 350z HR. Was not too bad. Like the first time though, some triming there and there. I'll throw a write up when I'm completely done. Have some 1050x's coming. Still on the Walbro 255 and stock cats as well. I'm shooting for 425whp... Trying to stay conservative.

I was able to use the intercooler brackets. Just had to trim the bolt holes on the ends and use a large washer in the middle of the bracket. Had to trim the 45* coupler from supercharger to lower IC pipe. From there, another 45* coupler to the Tial pipe (straight coupler was not going to do). Some trimming where the y pipe goes through the radiator support. A bit of trimming of the front radiator support. Yeah, y pipe was a bit difficult.

That’s awesome to know that u were able to get this kit to work with such slight modifications.

NissanTracker · 06-19-2020, 12:24 PM

Quote:

Originally Posted by BOLIO 671

That’s awesome to know that u were able to get this kit to work with such slight modifications.

Just started tuning with Seb

BTW, The Tial is absolutely annoying. It is just loud.... ALL.THE.TIME. If i give little load and constant throttle, the valve closes just slightly (not all the way) and starts sounding like a jet engine! Ewww, just ewwwwwww. And if I play with the throttle, I can make a "slurping" sound just the moment the valve is going to close.

Tial Q btw. I just ordered the recirc. bottom section so I can make a silencer for it. But gooood lord, it sounds like a massive wooosh of $hit.

nic370 · 06-19-2020, 12:43 PM

Quote:

Originally Posted by NissanTracker

Just started tuning with Seb

BTW, The Tial is absolutely annoying. It is just loud.... ALL.THE.TIME. If i give little load and constant throttle, the valve closes just slightly (not all the way) and starts sounding like a jet engine! Ewww, just ewwwwwww. And if I play with the throttle, I can make a "slurping" sound just the moment the valve is going to close.

Tial Q btw. I just ordered the recirc. bottom section so I can make a silencer for it. But gooood lord, it sounds like a massive wooosh of $hit.

Do you have a link to that recurculate part please ?

Sent from my SM-G960F using Tapatalk

NissanTracker · 06-19-2020, 12:49 PM

Quote:

Originally Posted by nic370

Do you have a link to that recurculate part please ?

Sent from my SM-G960F using Tapatalk

https://stmtuned.com/collections/uni...bottom-portion

I went with 1.5".

nic370 · 06-19-2020, 12:50 PM

Quote:

Originally Posted by NissanTracker

https://stmtuned.com/collections/uni...bottom-portion

I went with 1.5".

Awsome thanks

Sent from my SM-G960F using Tapatalk

redondoaveb · 06-19-2020, 01:31 PM

Quote:

Originally Posted by nic370

Awsome thanks

Sent from my SM-G960F using Tapatalk

I have an brand new, never used red one I'd sell.

Edit. I see you're in the UK, shipping would probably be outrageous.

nic370 · 06-19-2020, 01:48 PM

Quote:

Originally Posted by redondoaveb

I have an brand new, never used red one I'd sell.

Edit. I see you're in the UK, shipping would probably be outrageous.

Agh yeah
More than likely
Cheers anyway man

Sent from my SM-G960F using Tapatalk

NissanTracker · 06-19-2020, 01:55 PM

Quote:

Originally Posted by redondoaveb

I have an brand new, never used red one I'd sell.

Edit. I see you're in the UK, shipping would probably be outrageous.

pm'ed

NissanTracker · 06-23-2020, 10:39 AM

Don't order from STMtuned right now. I posted a link a couple days ago for the bottom half, they have an automated answering message and NOT responding to customers email. Try Amazon

redondoaveb · 06-23-2020, 11:11 AM

Quote:

Originally Posted by NissanTracker

Don't order from STMtuned right now. I posted a link a couple days ago for the bottom half, they have an automated answering message and NOT responding to customers email. Try Amazon

That's who I ordered the bottom half that you're looking at buying from me. They shipped mine right away. Maybe I got the last one.

DrBacon · 07-02-2020, 03:54 PM

Taking my kit apart for some changes and I noticed a little bit of oil sitting in the pipe that comes from the supercharger to the intercooler. Is this a bad sign lol?

http://imgur.com/a/qeruBkK

Also something worth mentioning, the rubber seals between the throttle bodies and plenum are fully shot some how.

http://imgur.com/a/I1EddWW

mikey1600 · 07-03-2020, 06:42 AM

tldr e85 Dyno - https://imgur.com/129aDFN

So finally my car is good to go! Ended up swapping in a stock 2nd hand low KM (miles for you guys) motor and continued on, currently running no air filter, waiting for turboguard to come. It was tappering off at 340-350KW~ and 6000-6500rpm and I told the tuners to rip off the air filter off as I've seen many others running without one and it's super restrictive, then boom, just over 400KW at the wheels (approx 550HP) without pushing etc.. I asked them to leave it there and not push any further.

I feel my boost levels are a bit low though, I've got the internals upgraded to the Si trim, running the stillen 9lb pulley, so was expecting around 12-13psi~? After a while I'll think about changing some pulleys and going more, right now I'm running 1050idx injectors and don't really want to start changing more again, already had to upgrade the 340 pump, went to a 525 so I could go next stage if needed.

It was making about 325KW on pump fuel and 6500RPM. All in all changing to e85 gained the peak power + 10-15% through-out the rev range, loving the extra power, on Nitto invo's in top of 3rd gear it starts to lose traction.

NissanTracker · 07-13-2020, 11:35 AM

Hi forum,

Created a thread regarding horrible idle with my supercharger setup. Originally posted it here, but I had the issues with the Air-water set up as well as air-air

Another Supercharger Idle problem thread | Starting to get desperate

NissanTracker · 07-13-2020, 05:21 PM

^ update to above. I put a straight through fitting and did squat with the idle. Still idles high after some driving

TopgunZ · 07-13-2020, 06:39 PM

Not sure this helps but your pump is way too small for 1050cc and your cats might be blown.

07-02-2020, 03:54 PM	#2771 (permalink)
DrBacon Enthusiast Member Join Date: Nov 2016 Location: Washington Posts: 285 Drives: 2014 Nismo Rep Power: 27364	Taking my kit apart for some changes and I noticed a little bit of oil sitting in the pipe that comes from the supercharger to the intercooler. Is this a bad sign lol? http://imgur.com/a/qeruBkK Also something worth mentioning, the rubber seals between the throttle bodies and plenum are fully shot some how. http://imgur.com/a/I1EddWW Last edited by DrBacon; 07-02-2020 at 05:16 PM.

07-03-2020, 06:42 AM	#2772 (permalink)
mikey1600 Track Member Join Date: Jul 2010 Location: Brisbane, Australia Posts: 503 Drives: MY11 370z Black Rep Power: 15	tldr e85 Dyno - https://imgur.com/129aDFN So finally my car is good to go! Ended up swapping in a stock 2nd hand low KM (miles for you guys) motor and continued on, currently running no air filter, waiting for turboguard to come. It was tappering off at 340-350KW~ and 6000-6500rpm and I told the tuners to rip off the air filter off as I've seen many others running without one and it's super restrictive, then boom, just over 400KW at the wheels (approx 550HP) without pushing etc.. I asked them to leave it there and not push any further. I feel my boost levels are a bit low though, I've got the internals upgraded to the Si trim, running the stillen 9lb pulley, so was expecting around 12-13psi~? After a while I'll think about changing some pulleys and going more, right now I'm running 1050idx injectors and don't really want to start changing more again, already had to upgrade the 340 pump, went to a 525 so I could go next stage if needed. It was making about 325KW on pump fuel and 6500RPM. All in all changing to e85 gained the peak power + 10-15% through-out the rev range, loving the extra power, on Nitto invo's in top of 3rd gear it starts to lose traction. Rusty, redondoaveb and Mariokart like this.

07-13-2020, 11:35 AM	#2773 (permalink)
NissanTracker Track Member Join Date: Jun 2016 Location: Massachusetts Posts: 724 Drives: 07' Nismo, 14' Nismo Rep Power: 29261	Hi forum, Created a thread regarding horrible idle with my supercharger setup. Originally posted it here, but I had the issues with the Air-water set up as well as air-air Another Supercharger Idle problem thread \| Starting to get desperate Last edited by NissanTracker; 07-13-2020 at 07:59 PM.

07-13-2020, 06:39 PM	#2775 (permalink)
TopgunZ A True Z Fanatic Join Date: Jun 2012 Location: Minneapolis Posts: 2,651 Drives: 06 350Z , 09 370Z MT Rep Power: 6833	Not sure this helps but your pump is way too small for 1050cc and your cats might be blown. __________________ ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Best upgrade/mod for 200-300$?	louiey370z	Engine & Drivetrain	10	06-09-2015 11:59 PM
Upgrade?	Dzel	Other Vehicles	83	03-08-2014 05:55 PM
Upgrade	Darryl79	New Roadster 370Z Owner	7	08-23-2012 02:21 PM
Big 3 upgrade ???	dbkustomz	Audio & Video	6	06-30-2012 07:00 AM

06-23-2020, 10:39 AM	#2769 (permalink)
NissanTracker Track Member Join Date: Jun 2016 Location: Massachusetts Posts: 724 Drives: 07' Nismo, 14' Nismo Rep Power: 29261	Don't order from STMtuned right now. I posted a link a couple days ago for the bottom half, they have an automated answering message and NOT responding to customers email. Try Amazon

07-13-2020, 05:21 PM	#2774 (permalink)
NissanTracker Track Member Join Date: Jun 2016 Location: Massachusetts Posts: 724 Drives: 07' Nismo, 14' Nismo Rep Power: 29261	^ update to above. I put a straight through fitting and did squat with the idle. Still idles high after some driving