|
I've got a question for you experienced modders out there. How much should I torque down the AN fittings for those lines that are supplied from the GTM kit? I
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-08-2010, 08:30 AM
|
#10 (permalink) |
|
Track Member
 
Join Date: Mar 2009
Location: Lithia, FL
Age: 52
Posts: 552
Drives: 09 Nissan 370z CS M6
Rep Power: 188   |
I've got a question for you experienced modders out there. How much should I torque down the AN fittings for those lines that are supplied from the GTM kit? I am currently getting a little seepage from the edge of where the fittings meet the steel braided line. Is this something to be concerned about? When I get her back up on stands, I will take some pics and post (though that probably will not happen until at the earliest the evening of Tuesday - 9 March).
__________________
Dynojet 285 HP/245 TQ (pre CBE)// Agency Power CBE // GTM Test Pipes // JWT Pop Chargers // B&M Short Shifter // Eibach Springs // Powder-coated Akebono's // Powder-coated Strut Bar // Black Chromed 19" Rays // // Redline Designs Graphics TipsZ journal |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Real Auto Dynamics built and R/T tuned built motor TT | Mr.Squeeze | Forced Induction | 132 | 04-18-2014 06:09 PM |
| Anyone done a DIY for a 34r cooler install? | bigdog1250 | DIY Section (Do-It-Yourself) | 7 | 07-05-2012 10:38 AM |
| Oil Cooler Install | Zedx | Engine & Drivetrain | 10 | 05-19-2011 02:35 AM |
| install oil cooler? | Mt Tam I am | Nissan 370Z General Discussions | 5 | 08-25-2010 09:08 AM |
17Likes
Threaded Mode
