|
Would there be a difference between using -8 lines instead of -10? I installed everything in the DIY except that I used smaller lines. In 105 degree F heat, it
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
08-05-2011, 08:35 AM
|
#11 (permalink) |
|
Base Member
Join Date: Jun 2010
Location: DFW
Posts: 238
Drives: Boss 302, Frontier
Rep Power: 16  |
Would there be a difference between using -8 lines instead of -10? I installed everything in the DIY except that I used smaller lines. In 105 degree F heat, it averaged a little below 220. Does that sound right? It never went over that while I was pushing it a little bit here and there.
New update: I think it is fine. I have been cruising around and the temparture is at 190 in 105 F degree weather. Last edited by Nikkolai; 08-07-2011 at 06:04 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Real Auto Dynamics built and R/T tuned built motor TT | Mr.Squeeze | Forced Induction | 132 | 04-18-2014 06:09 PM |
| Anyone done a DIY for a 34r cooler install? | bigdog1250 | DIY Section (Do-It-Yourself) | 7 | 07-05-2012 10:38 AM |
| Oil Cooler Install | Zedx | Engine & Drivetrain | 10 | 05-19-2011 02:35 AM |
| install oil cooler? | Mt Tam I am | Nissan 370Z General Discussions | 5 | 08-25-2010 09:08 AM |
17Likes
Threaded Mode
