|
FYI - The "MOC-SP1FT Mocal Sandwich Plate- 20mm Thread" has a 1" nut and requires a deep socket (depth is 1 1/8" or greater) but a Outer diameter of 1.41"
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
07-29-2011, 08:25 AM
|
#10 (permalink) |
|
Base Member
Join Date: Oct 2009
Location: Denver
Posts: 16
Drives: 350Z Nismo
Rep Power: 16  |
FYI - The "MOC-SP1FT Mocal Sandwich Plate- 20mm Thread" has a 1" nut and requires a deep socket (depth is 1 1/8" or greater) but a Outer diameter of 1.41" is too large (i.e. thick walled impact socket), but 1.33" OD will work. Not sure the maximum OD other than it's between those values.
You can fit an adjustable wrench in but it's easier to install with a socket. Pulled it out here recently to swap out the Aeroquip socketless hose after a friends setup blew off the line and mine was uncomfortably pulling away (~2mm gap). BTW he had plenty of slack and had daily driven the car for a month, but it didn't pop off till a track day. Last edited by NismoZ_840; 08-17-2011 at 06:59 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Real Auto Dynamics built and R/T tuned built motor TT | Mr.Squeeze | Forced Induction | 132 | 04-18-2014 06:09 PM |
| Anyone done a DIY for a 34r cooler install? | bigdog1250 | DIY Section (Do-It-Yourself) | 7 | 07-05-2012 10:38 AM |
| Oil Cooler Install | Zedx | Engine & Drivetrain | 10 | 05-19-2011 02:35 AM |
| install oil cooler? | Mt Tam I am | Nissan 370Z General Discussions | 5 | 08-25-2010 09:08 AM |
17Likes
Threaded Mode
