|
Exhaust was fine, though IDK how Stillen's lines up. I used a wrench inside the bracing on the nut side and hit my wrench on the bolt side (external side)
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
01-05-2022, 10:57 AM
|
#24 (permalink) |
|
A True Z Fanatic
Join Date: Jun 2011
Location: Madison, WI
Posts: 1,397
Drives: 2009 370Z
Rep Power: 16805   |
Exhaust was fine, though IDK how Stillen's lines up.
I used a wrench inside the bracing on the nut side and hit my wrench on the bolt side (external side) as hard as I could. Also used blue threadlocker. Not ideal, but best I could do with the space. There's no room to turn a wrench, even a ratcheting one, inside the hollow rear bracing piece.
__________________
@stupidtoycars | My track vids 09 7AT|MCS 2WNR|Topgunz Rotrex|Ecutek (Eugene)|Maxxis RC1|Titan-7 TS-5|OSG LSD|Rear Mount Derale Oil Cooler (WIP)+25 Trans Cooler|Fismo|G-LOC R12/R10|Zeta III L|NLR Wing and Splitter|CJM Pan and Fuel Hat|Radium Surge Tank|AP Racing CP9668 |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2015+ Nismo Rear Chassis Brace Install | nismolucino | DIY Section (Do-It-Yourself) | 9 | 02-22-2021 11:00 AM |
| Z1 Brake Master Cylinder Brace - Install Help | 140BPM | Brakes & Suspension | 10 | 04-22-2019 09:06 PM |
| Has anyone been able to install a Z1 master cylinder brace? | gshort24 | Brakes & Suspension | 4 | 08-11-2016 02:05 PM |
| Rear brace bar removal/install? | TriNismo | Exterior & Interior | 8 | 08-17-2015 11:02 PM |
436Likes
Threaded Mode
