06-14-2012, 01:18 PM
|
#5 (permalink)
|
|
Base Member
Join Date: Oct 2010
Location: Hiram, GA
Posts: 83
Drives: 2011 370Z track rat
Rep Power: 15
|
Quote:
Originally Posted by mults
Where do the ball studs attach to? I just looked at the engine compartment and did not see where they would mount.
|
There is a plastic rivet clip on the front of the brake cubby cover, just pop it out and remove from the top side. You will have to reach into the fender, get behind the fender liner (it just snaps into place) install the lower ball stud mount with the provided lock nut (when you install the ball stud it has a captive washer get this washer under the brake cover so it lays over it).
Then install the hood brackets with the ball facing inboard.
Snap the parts into place and then the final lock pins on the hood bracket end (note that the "sloped" ball socket on the strut rod goes forward).
|
|
|
Similar Threads
15Likes
Threaded Mode
