![]() |
Originally Posted by Jinxx Just wondering what are the odds of the factory breaking ..haven’t seen much info on them breaking ...do most people not change them unless they build
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#9 (permalink) | |
A True Z Fanatic
Join Date: Nov 2014
Location: South Carolina
Age: 58
Posts: 15,204
Drives: 13’ 370Z TS 7A/T
Rep Power: 2684395 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]() Quote:
That’s hooking pretty dang good; for a 3300-3400-Z (minus driver). Shouldn’t be an issue for you, unless you’re launching harder than that...Most of your lower 10sec & the (1) high 9sec 1320ft. Z , use full blown drag slicks. As mentioned above: axles are weaker than driveshaft: So if you’re fortunate to have that much power to the wheels & launching hard enough to break an axle,,,I’d say congratulations. As not many people have actually done it. 0 reports that I’ve seen on CF driveshaft breaking. You must be getting loaded up & running in Darlington soon? Unsure when you go,,,I’d like to come out. I’ve ran @CarolinaDragway a few times in Jackson SC. A 10sec. Pass would be awesome ![]()
__________________
MazWorx built long block | FI-TT-100 Stage 2.75 | IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html |
|
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Diff Swap and new half shafts | mdxj | Engine & Drivetrain | 2 | 03-12-2014 02:40 PM |
Feeler: Drive Shaft Shop Axles GB | phunk | Group Buys | 12 | 10-14-2013 01:16 PM |
Stock engine strength | Mino | Nissan 370Z General Discussions | 1 | 06-17-2012 04:20 PM |
Strength of the Front Bumper | gurneyeagle | Nismo 370Z | 16 | 12-29-2011 09:47 AM |