TBatt

TBatt Wrote :
Last night I found the problem. A connector was not fully seated on the transmission harness that has the hookups for the O2 sensors. There is a single wire connector that goes up near the starter motor that was not seated all of the way. When it was fixed the car started up.
--------------------
Sorry to bug you 6 years after you posted this - but i have having the same trouble (No recent work done to the car)
I checked the switch with an ohm meter and checked the fuse and the only relay i could find in the IPDM.

The wire you referred to .... where did it come from / Go to?
Thanks Tons for any help you could offer.
Dylan

PM’d you !

Crazy enough I'm in Huntsville and have been looking for a new (to me) car. I had test drove a Nismo up at Jerry Damson but it sold before I got the go ahead from my wife. I was wondering if you where available next week to meet up so that I can check out the 370. I'm Montgomery this weekend but will be back in Huntsville on Monday.

-Edward

Sorry for the slow response but I've been crazy busy at work.

Send via PayPal. My account is tbatt@knology.net

Sounds good where do I send the payment and shipping info too?

The complete kit, with shipping in the US is $175.

Hi ,
How much do you charge for your stillen idler pulley and hd belt upgrade ?

Yes, but i don't have them with me at the moment, they are at my office.

Nice car- Roll Tide ('15)!

Can you share your offsets?

Agree whole heartily! I've always looked at car modding as the cost of entertainment. it is just that I have never gone this far in so I was looking to see if someone knew a secret handshake............

You didn't say if you had the sport brakes or base in your OP. The base brakes are super easy as you only have one bleeder valve per wheel. The sport brakes are a little harder to do because you have...

Fired up my 09 Super Charged Z last night with the TDX exhaust, test pipes and Mil Spec cats. OMG! At idle it sounds almost V8 like with a very deep rumble. As the rpms go up under acceleration it...

Well the demon bolts lived up to their name. Dang, they are hard to break loose but I won! The CSC was just about to go out. The dust boot had already broken down and torn so it was just a matter...

But, you would miss out on all of the fun installing it. I thought that the fuel pump mod was far worse than the intake install.

You probably need to bleed the brakes some more. It takes a bit of bleeding to get all of the air out of each piston cavity. I had the same problem. I use a vacuum bleeder that seems to work well...

I have seen pads start to squeal when they reach about 50% life. The cure I found was taking the pads off and slightly beveling the edge of the pad (like most new pads are). That may help but if you...

Not really, the transmission was out for a clutch upgrade. That is why the connector was loose. It was my fault :mad:(don't let my wife know it though).

Got the Z running last night. The problem was a loose connection on one of the tranny connections. Once the connector was mated properly it fired right up. The new clutch is awesome. Very nice...

Fired up my 09 Super Charged Z last night with the TDX exhaust, test pipes and Mil Spec cats. OMG! At idle it sounds almost V8 like with a very deep rumble. As the rpms go up under acceleration it...

Not really, the transmission was out for a clutch upgrade. That is why the connector was loose. It was my fault :mad:(don't let my wife know it though).

I love my QJ system. That and a "Magic Creeper" together is the cat's meow! https://magiccreeper.com/ One thing that I did with mine is to label them Left and Right so that the locks are always...

Fired up my 09 Super Charged Z last night with the TDX exhaust, test pipes and Mil Spec cats. OMG! At idle it sounds almost V8 like with a very deep rumble. As the rpms go up under acceleration it...

Fired up my 09 Super Charged Z last night with the TDX exhaust, test pipes and Mil Spec cats. OMG! At idle it sounds almost V8 like with a very deep rumble. As the rpms go up under acceleration it...

Jegs.com is where i got mine. Galeforce can set you up with the A pillar mount. His work is simply amazing and it will look like the car came with it.