Megan370z

headunit was sold a while ago

what would you want for just the headunit and headunit faceplate. I don't need the leather console or navigation screen.

And what would you want for just the headunit's faceplate if you are willing to sell that by itself!

Hey I was going to ask did you ever find out how to fix the u1024 trouble code

love the exhaust work photos. Thanks for sharing@

hey, just looking through some of your photos. that's some amazing craftsmanship. how's the car looking these days?

@ LafitteZ, yes the engine is it, I daily drive it right now , but all my plans changed due to personal reason . the built is greatly on hold.

did that vhr to hr heads work out ok?

so in the end, was there an advantage with the HR conversion? Or did you end up losing power over stock intake manifold? sorry for a noob question

Mitco39 , yup that was me looks my videos on youtube XChacalX2008

Not sure if you seen this, but I think its your Z.

2009 Nissan 370Z Rips it down a Track(MUST SEE) - YouTube

a quick guess without accounting for research and developpment . burns collector sells for 530$ /pair head flange probably around 120$ pair TP/Cat flange = 40$ 3 hours of tube prepping and...

I reflashed back to stock and the code went away then I put Uprev back in the ECU. I didn't do a test drive to see if it will come back , its gonna wait till tomorrow. I'm thinking it might have...

I hate doing this and since my hydraulic course was taken years ago, I will try to make it short. there is in fact an hydraulic pressure loss/gain in any hydraulic system the pump &...

that bolt can be extremely hard to remove , dont worry you wont break the bolt unless you absolutely have to use an 1''inch breaker bar if nothing else worked then it might snap. I had to use PB...

The time as come to finish the Ver 1.0 of my Aero body kit It took me 7 months to get this result. Could it been better ? Maybe but doing a project like this when you never did anything close to...

just a headup, the Cusco LSD can be found way cheaper than this somewhere else. (other forum) I got 1300$ shipped to Canada.. and you mentioned some adjustability beside the other but not the...

im still laughing at you you still fail to see why the wing is on the car and not on for the look who care if it look ridiculous anyway ?? ohh excuse me, 98% of the370z.com folks prefer...

im gonna refresh them a bit then take a couple pictures ... on a another better topic!!! Look at this 76 3/8'' wing its almost done and just require to drill the holes in the right...

just want to share the very last development before a little while as i have my ankle surgery in a few days... No the wing isnt finish as it need another epoxy coat then final sanding then clear...

This is something an aggressive bolt-on/custom and loud setup might want to look at. The stock Knock sensor are very sensitive and can be trigged by outside noise than an actual Ping/Knock Knock...

nice job on the CAD.. i see what you did there on the rear quarter panel :tup:

nice job on the CAD.. i see what you did there on the rear quarter panel :tup:

For the few guys who still remember my Z for now this is where the project is going ! Someone gonna enjoy this wing :stirthepot: depending how much CF left I have.. it might be finish in a...

For the few guys who still remember my Z for now this is where the project is going ! Someone gonna enjoy this wing :stirthepot: depending how much CF left I have.. it might be finish in a...

For the few guys who still remember my Z for now this is where the project is going ! Someone gonna enjoy this wing :stirthepot: depending how much CF left I have.. it might be finish in a...