Mr. G. Brettin's Slow Motion Leg Hump

gbrettin · 07-03-2022, 10:53 AM

Sirnixalot - I ordered those greatneck tools you pointed out. Thanks. Deep down having those bent lines annoyed me but not enough to take it off previously.

Brake lines are all done with the exception of one line for the driver's side front wheel. The line I originally had was too short by two inches. I ordered another -3 line that was longer, but the ends were -4. Oopps. I have another one ordered so it should be here pretty soon, probably on Tuesday July 5th.

I did notice that there are black rubber coated lines AFTER I ordered all my -3 lines.... god that is annoying. The current -3 lines are like little saws that are F'ing up the engine bay paint. I need to tape the lines with felt so it doesn't buzz saw everything.

Aside from that, I adapted all the pipe and thread lines to AN on the master cylinder and on the line where the hardline use to be.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Racing in Slow Motion IV	MightyBobo	The Lounge (Off Topic)	4	03-12-2013 08:12 PM
Racing In Slow Motion IV	Robert_K	The Lounge (Off Topic)	1	07-13-2012 11:01 AM
Slow shipping slow response slow everything	thispecialk	Nissan 370Z General Discussions	15	11-01-2010 08:23 PM
Racing in Slow Motion	MightyBobo	The Lounge (Off Topic)	2	12-17-2009 03:27 PM
IIHS Small Car Test: Three Gruesome Slow-Motion Crash Videos	AK370Z	Other Vehicles	13	04-15-2009 09:42 AM

07-03-2022, 10:53 AM	#11 (permalink)
gbrettin A True Z Fanatic Join Date: Oct 2010 Location: Portage, MI Posts: 2,304 Drives: Tricycle Rep Power: 589452	Sirnixalot - I ordered those greatneck tools you pointed out. Thanks. Deep down having those bent lines annoyed me but not enough to take it off previously. Brake lines are all done with the exception of one line for the driver's side front wheel. The line I originally had was too short by two inches. I ordered another -3 line that was longer, but the ends were -4. Oopps. I have another one ordered so it should be here pretty soon, probably on Tuesday July 5th. I did notice that there are black rubber coated lines AFTER I ordered all my -3 lines.... god that is annoying. The current -3 lines are like little saws that are F'ing up the engine bay paint. I need to tape the lines with felt so it doesn't buzz saw everything. Aside from that, I adapted all the pipe and thread lines to AN on the master cylinder and on the line where the hardline use to be.