Topgunz - air to air upgrade

milkcow500

Question for those of you with the Tial QRJ. I'm getting a weird boost loss issue. I've been able to get most of it back by messing around with the couplers and whatnot, but i just wanted to make sure my V band clamp was correct for the bvp.

Did any of you guys have an oring in your setup and is this correct? My clamp is the Tial Sport 001624.



Sent from my SM-N930V using Tapatalk

StillenZ84

Yeah it looks to be installed correctly. Even if that clamp is tight, you can still twist and tighten the Tial. The bottom twists on just like the side does. I had the same issue and it was loose. Just twist the whole BPV and tighten it up. Might not be the issue but worth a shot.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34

milkcow500

Thanks, I'm going to check that this weekend just to be sure. I spoke with a tech over at TiAL and they told me to use some blue threadlocker just in case.

As for the O-ring, he said that it should function fine with or without it.

Sent from my SM-N930V using Tapatalk