http://uploads.tapatalk-cdn.com/2016...c387f4ec0f.jpg

Still only 9 psi.


Sent from my iPhone using Tapatalk

No the cog isn't on it.


Sent from my iPhone using Tapatalk

hope it all gets finished for you today mate!

We are talking about using the cog set up, I need to look at the numbers tomorrow when I'm sober.


Sent from my iPhone using Tapatalk

That dyno plot doesn't look too bad. It's dipping rich for sure, but it goes back to normal by 6,500. So your upper range power numbers are there. Do you know how much timing they have in the tune? My guess is that they're still in "safe mode" and just trying to stabilize the AFRs before they start pushing the timing. Now if you're low on boost, then that's a different story.

Back when you ha a healthy tune, and were running 9psi, you were at 418whp? So, so far, you've gained ~17whp on the same amount of boost. I'd consider that in line with the better intercooler and headers. Now if you can figure out how to raise the boost, you should start seeing some healthy gains. If the car has fuel to spare, and is healthy and happy at this 9psi, I'd guess you'd be seeing closer to 500whp at 11-12psi.

The rich dip isn't killing the numbers, it's just too rich in the middle. You might be leaving some 'area under the curve' on the table, but it comes back at the top. Your torque curve stays flat when it goes rich, so it's not choking itself out.

We are +27/+47

http://uploads.tapatalk-cdn.com/2016...a723b81461.jpg


Sent from my iPhone using Tapatalk

:happydance:Nice!!! 450 and 360!

http://uploads.tapatalk-cdn.com/2016...56847d9824.jpg


That doesn't sound good!


Sent from my iPhone using Tapatalk

Stop it! Nooo! He joking?!

Stillen Air to Air setup
 

I was just told something went wrong in the supercharger,good night I'm dreaming evil things tonight!


Sent from my iPhone using Tapatalk

Jay your FN playing with us arent you, I'm sitting here smiling ear to ear being happy you stuck it out and things are coming togther and then you DROP THAT!! NO MAN ! F@ck!!

Damn vortech input shaft bearings they'll getcha everytime. Probably to tight on the belt or something. That or something got sucked in only two ways they die unless it was low on lube and smoked the output bearings. Sucks balls fo sho.

Oh my goodness, you've got to be kidding me... I don't know what to say.

WTF! :confused: I have been following your thread from the beginning. I hope this is not true, if so PLEASE start a GoFundMe account and I will be one of the first to contribute... :tiphat:

I think I'm dreaming right .... right?:confused:

Hope that's not true !? :shakes head: