Robispec Harness Bar Install

Rusty

Once you have the stock bar out. Put your spacer plates that was on the end of the Robispec harness bar in place on the frame bracket sticking out. The bar and spacer plates ONLY go in one way. They WILL NOT fit the other way. THE ROUNDED PART OF THE SPACER PLATE IS ON TOP! SAME WITH THE BAR! My bar went in tight. Thought for awhile that I might have to use a porti-power to jack the frame apart. Had the bar in backwards. Turned the bar around. And it was still on the tight side. But it went in. I put the driver side spacer in first. Next I put the bar in. Raised up the right side alittle and dropped the that spacer into place. Align the bolt holes, and used the bolts that came with the bar.

Attached Images

	007.JPG (253.6 KB, 337 views)
	008.JPG (259.2 KB, 364 views)
	009.JPG (251.8 KB, 448 views)
	010.JPG (263.3 KB, 804 views)
	011.JPG (247.8 KB, 428 views)

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

Rusty

Next. In the first picture. PUT THAT PIECE IN FIRST, before the other panels. Other wise you WILL BE CUSSIN"! Then reassemble your interior. Play attention to the clips and screws that you took out the how they fasten. and there you go. All done.

Attached Images

	012.JPG (252.1 KB, 583 views)
	014.JPG (258.6 KB, 792 views)

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html