Fuel Gauge (Dots) Problems?

FPenvy

yea mine only does it on the first dot and once in a blue moon the first 2 will be missing when I fill up. but most times it's just driving home, shut down, turn on, and they are back on.

__________________
324whp/258wtq AAM Tuned |F.I. NonRes CF CBE/NonRes TestPipes #373|UpRev Tuner|Akuma Motorsports Intakes|Z1 34 Row Oil Cooler

cycy89

It's just annoying. The last thing I wanna do while driving is guessing how much gas I have in the car.

__________________
Fast Intentions Twin Turbo Kit GT2860RS, 677WHP|FI 34 row oil cooler|F.I. CBE|Fast 500E return fuel system|FI trans cooler|FI billet aluminum flex plate|Excedy clutch packs|ENKEI RP03|BC BR coilovers|SEIBON Carbon|EVO-R Rear fog light|GTR push start|Whiteline sway bars, Diff bushing|DSS axles|ECUTekW/FlexFuelTune

FPenvy

based mine only seeming to be not lit it doesn't scare me. it's more of the lights malfunctioning at the top. the bottom hasn't misled me yet as to whats left. but I will say I never let it get below a 1/4 before I fill it back up.

__________________
324whp/258wtq AAM Tuned |F.I. NonRes CF CBE/NonRes TestPipes #373|UpRev Tuner|Akuma Motorsports Intakes|Z1 34 Row Oil Cooler

theDreamer

The two main problems are:
-Fuel sender
-Injector size

The fuel sender seems to be pretty spotty, had mine replaced once and it fixed it for awhile but came back now & again. The injector size is causing problems with MPG/Miles to empty/bottom dots. The system is expecting the injectors to run a certain way but with larger injectors they pump more fuel but less often causing the system to think it is running more efficiently. This is not an ECU issues it is another system in the Z which measure MPG/Range and needs to be adjusted so the dots & read outs can properly show.

__________________
theDreamer's Z // Fast Intentions // Uprev // GTM // HKS // TEIN
theDreamer's Silvia // URAS // GREDDY
Houston Zs // Facebook // Twitter // Instagram

SouthArk370Z

Next time the display messes up, check the Range display. If it matches the gauge (ie, close to zero), it's probably the tank sensor or wiring (a not uncommon problem as mentioned above). Else I suspect a bad gauge, possibly a common ground/supply for the dots.

__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub
Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma

Rusty

If you never been inside the tank. It has 2 float sensors. One on each side. They're both a resistor type of sensor. As the float moves up and down. The other end of the arm moves on a resistor grid, changing the voltage signal back to the gauge basically. If one of the floats has absorbed some fuel. It will not float as high. Giving you a low reading. Or if the arm is bent. It might not be going high enough to trigger the last full light on the gauge.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

cycy89

I think you're right. My tank is pretty much full and the last few lights never light up.


Sent from my SM-G928T using Tapatalk

__________________
Fast Intentions Twin Turbo Kit GT2860RS, 677WHP|FI 34 row oil cooler|F.I. CBE|Fast 500E return fuel system|FI trans cooler|FI billet aluminum flex plate|Excedy clutch packs|ENKEI RP03|BC BR coilovers|SEIBON Carbon|EVO-R Rear fog light|GTR push start|Whiteline sway bars, Diff bushing|DSS axles|ECUTekW/FlexFuelTune

KevinN

Yeah I have the same problem. Have the f.i. TT and flex fuel. Even before flex fuel and e85, the problem was there.

Chan Chee Hoe

My worse,i never pumped full tank,but last week,my Country's National Day,petrol is a tad cheaper,pumped full tank,now used 180km,but still no drop in dots....worrying.

cycy89

But I think the range is fairly accurate. I don't have the balls to actually test it tho lol. Always fill it up when it goes under half tank.

Sent from my SM-G928T using Tapatalk

__________________
Fast Intentions Twin Turbo Kit GT2860RS, 677WHP|FI 34 row oil cooler|F.I. CBE|Fast 500E return fuel system|FI trans cooler|FI billet aluminum flex plate|Excedy clutch packs|ENKEI RP03|BC BR coilovers|SEIBON Carbon|EVO-R Rear fog light|GTR push start|Whiteline sway bars, Diff bushing|DSS axles|ECUTekW/FlexFuelTune

Rusty

D'oh. I just dawned on me. I should have included it in my earlier post. Also a part of the resistor grid may be dead. Had a '99 Grand Cherokee that had a dead spot in the grid. The fuel gauge would read fine from full to just above a half tank, then quit reading until the fuel level dropped just below a half tank. But when it was in that dead zone. The gauge would read empty. Thinking about how the Z grid could be. The dead zone could be from where it stops reading to full dot.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

Cory Gillmore

Sorry to revive an old thread…but there are two fuel sending units in our Zs, correct? One on the passenger side that is a part of the fuel pump assembly, and another on the drivers side that is only a fuel sending unit? I’ve been having a P0300 that’s now turned into a P0305 and my fuel level gauge has just started acting funny. So I’m suspecting my fuel pump hat is broken or something. I was thinking about just buying a new fuel pump assembly and also buying the fuel sending unit for the drivers side just to cover all the bases.

But just to confirm, if I buy a fuel pump assembly it does come with that sides fuel sending unit?

__________________
09 S/T 6MT: AAM S-Line catback exhaust Ti tips, Z1 CF CAI, Z1 ported intake plenum, Z1 high energy coil packs, tuned with ECU-Tek @ Z1: 332whp 261ftlbs

Spooler

Just buy a new billet fuel pump top hat from CJ Motorsports. You won't have that issue again.

Cory Gillmore

Thanks fellas. But question is more about the fuel sending units. If I buy a fuel pump assembly, it comes with the fuel sending unit for the passenger side, correct? Then I could just buy the fuel sending unit for the drivers side and that would cover both?

I would definitely pick up a billet top hat. Is that a pretty straight forward install on a brand new fuel pump?

__________________
09 S/T 6MT: AAM S-Line catback exhaust Ti tips, Z1 CF CAI, Z1 ported intake plenum, Z1 high energy coil packs, tuned with ECU-Tek @ Z1: 332whp 261ftlbs

JARblue

The OEM top hat uses plastic threaded rods that get brittle and break over time. CJM billet top hat is the way to go.

__________________