Transmission removal and CSC

Joe@ZSpeed · 02-07-2013, 10:52 PM

Quote:

Originally Posted by Denny McLain

I seriously doubt that if flushed well. Rubber is not going to deteriorate for the sake of deteriorating if properly cleaned. There was a pretty high rate of failure on factory CSC's and I'm sure if you tore a failed one apart, the O ring might very well be the culprit but that is not a apples to apples comparison.

Denny

I've torn lots of them apart, Over 50 actually and these are just the ones I received in one piece. A lot of them just break when the release bearing itself breaks off its plastic mount, That's if the seals lasted long enough for this to happen.

If you flushed it out with any kind of solvent you most likely got in on/in the release bearing also which will wash out the grease in it causing the bearing to lock up which spins the entire housing breaking/melting it off the front of the CSC.
Save yourself the trouble and NEVER reuse it, Unless of course you like tow trucks and pulling your trans for fun..

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transmission problem (?) after a transmission fluid change	EWarren	Engine & Drivetrain	7	07-28-2014 11:44 AM
A/C Removal	Sh0velMan	Track / Autocross / Drifting / Dragstrip	2	11-09-2012 11:09 AM
Fender removal	rjsf	Exterior & Interior	9	10-20-2012 05:01 PM
Quick HELP....Hub removal!	spearfish25	Brakes & Suspension	3	04-23-2012 09:48 AM
help with gum removal	thispecialk	Nissan 370Z General Discussions	7	08-05-2009 10:41 AM