|
The reason you are burning oil is more than likely due to the ring gap was set too large causing this issue. Normal for a Forced induction car. There is
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
12-05-2020, 07:45 PM
|
#1 (permalink) |
|
A True Z Fanatic
Join Date: Jun 2014
Location: Ga
Posts: 14,123
Drives: 2013 Nismo 370z
Rep Power: 2684394   |
The reason you are burning oil is more than likely due to the ring gap was set too large causing this issue. Normal for a Forced induction car. There is a fine line setting the ring gaps. Too large and oil consumption and blow bye is an issue. Too tight and sticking a ring due to the extra heat of a FI car. My first built engine burned a little bit of oil. My new one does not. This issue could have also been due to improper break in procedure. You are going to burn oil due to the reasons above. Nothing is going to stop it unless you have it built again properly.
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Key fob shell | PeachyZ | Exterior & Interior | 17 | 12-07-2020 03:22 PM |
| Shell Rotella T6 5W-40? | Katana29 | Engine & Drivetrain | 7 | 11-12-2020 08:07 PM |
| Where to buy key fob shell? | cjeezy | Nissan 370Z General Discussions | 12 | 06-29-2016 08:21 AM |
| Shell Rotella T6 5W-40 | harman.khinda | Engine & Drivetrain | 8 | 05-11-2012 06:35 PM |
| Shell Gas and Your Z | Omikron | Texas | 16 | 03-23-2012 01:47 AM |
13Likes
Hybrid Mode
