|
On the JWT clutch you need to ensure that the fingers of the pressure plate are not hitting the center of the clutch disk at full stroke (pedal on floor)
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
10-02-2019, 10:51 AM
|
#24 (permalink) |
|
A True Z Fanatic
Join Date: Mar 2011
Location: Ohio
Posts: 1,304
Drives: Nissan
Rep Power: 343000   |
On the JWT clutch you need to ensure that the fingers of the pressure plate are not hitting the center of the clutch disk at full stroke (pedal on floor) I have seen quite few of the JWT have interference issues when new. If the pressure plate fingers hit the disk when you have the pedal to the floor it can cause shifting issues and cause gear grinds.
You can normally tell this is happening at idle as well, if you push the pedal all the way to floor you can normally hear it scrape a little and can also cause it to be hard to get into gear. if you let up a little it will go right into gear.
__________________
http://photos.zspeedperformance.com/...ardsize=468x60 Phone 937-506-7224 E-Mail Sales@Zspeed.com www.ZSPEED.com |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5th gear scratch (not a grind) | NismoNY | Engine & Drivetrain | 27 | 11-20-2018 09:40 AM |
| Transmission Grind 1st Gear | Dragon_Ball_Z | Engine & Drivetrain | 16 | 10-07-2014 06:00 PM |
| dreaded 6th gear grind.... | edub370 | Nissan 370Z General Discussions | 4 | 06-30-2012 02:21 PM |
| 2nd gear grind =/ | elmz | Nissan 370Z General Discussions | 19 | 06-09-2012 09:49 AM |
| 6th Gear grind | Big J | Nissan 370Z Owners Manual / Service Manuals | 57 | 02-08-2012 04:09 PM |
21Likes
Threaded Mode
