DIY: of complete FOG LAMP install

Originally Posted by scottIN

For those having issues with the bolt spinning / loctite, here's what I did: spray the nuts with some PB Blaster. Let it sit for about 30 seconds. Then take your 10mm and do a quick / hard turn on the nuts to break the (now softened) loctite. Both of mine spun right off doing this. Less than a minute to remove it.

I'd normally break loctite with a wrench / hammer combo, but I couldn't get a hammer in there. A quick turn should accomplish the same thing. The key is, you have to do this first, not after you've jacked with them and spun the head.