|
Longshot as the thread is so old, but has anyone had issues with seepage from the seal between the mocal sandwich and the OEM sandwich for the small cooler? It
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
08-09-2021, 02:31 AM
|
#40 (permalink) |
|
Base Member
Join Date: Jun 2017
Location: abu dhabi
Posts: 2
Drives: 370Z GT, 2015, AT7
Rep Power: 9  |
Sandwich plate leak
Longshot as the thread is so old, but has anyone had issues with seepage from the seal between the mocal sandwich and the OEM sandwich for the small cooler?
It seems the centre threaded fitting doesn't tighten the sandwich down all the way, as if its designed so that the oil filter installation does the final seal compression. With the 1" fitting tightened down the sandwich can still rotate without too much effort. Is this normal or do others find its sealed up tight before the filter is installed? The seepage starts after a 2 or 3 100km drives only, when I check it I find the sandwich fairly easy to rotate when I move it by grabbing the hose fittings. Wouldn't mind some comparisons before I remove the OEM cooler and try again with the Mocal installed directly on the block. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Real Auto Dynamics built and R/T tuned built motor TT | Mr.Squeeze | Forced Induction | 132 | 04-18-2014 06:09 PM |
| Anyone done a DIY for a 34r cooler install? | bigdog1250 | DIY Section (Do-It-Yourself) | 7 | 07-05-2012 10:38 AM |
| Oil Cooler Install | Zedx | Engine & Drivetrain | 10 | 05-19-2011 02:35 AM |
| install oil cooler? | Mt Tam I am | Nissan 370Z General Discussions | 5 | 08-25-2010 09:08 AM |
17Likes
Threaded Mode
