SPC front camber arms?

Originally Posted by synolimit

I plan on buying ams, checking the welds and reenforcing them if need be. On the bends I might weld a bracket or rod from end to end to make a triangle part. Steels steel so I'm sure they'll be tough. Better to have them steel than aluminium you have no idea how it was made. The bushings are definitely getting replaced with the delrin? Or something? And the tie rod end can be replaced anytime which again ill replace because both ams and kinetix look like they're cast and forged/milled is better/stronger like SPL...





When done I may have kinetix money into it but it will be much better.

Originally Posted by jooonnn

I agree id rather have cheap steel over cheap aluminum but not sure what "steels steel" is referring to, since not all steel is the same


Sent from my iPhone using Tapatalk

Originally Posted by synolimit

I just mean I'm sure its a mild steel tube. To me milds milds. Yes cold rolled is a little stronger than hot rolled, but for this part here, that U shape will be more than fine in either mild.

Now if talking SS or heat treated armour plated mild, then yes, huge difference.

Originally Posted by jooonnn

Yup just givin ya a hard time because i saw your awesome build skills on your thread . What would your personal recommendation be for the less tech savvy less diy person who at most would be street driving about 98% of the time (clearly id spring for spl if i tracked) : kinetix or spc front camber arms?



Sent from my iPhone using Tapatalk

Originally Posted by Rusty

You guys talk about the tie rod end. It has nothing to do with it. It's the upper ball-joint.